XIONG Ziliu
,
CAI Qingwu
,
JIANG Haitao
钢铁研究学报(英文版)
The influence of hot-rolled process on microstructure in TRIP steel and the heredity characteristic from the hot-rolled microstructure to annealed microstructure are investigated. The results show there are two kind of hot-rolled microstructures under different coiling temperatures. One is composed of coarse grains of ferrite, pearlite and bainite, and the other is composed of small grains of ferrite, bainite and austenite. After annealing, the first kind of hot-rolled microstructure is greatly refined, and volume fraction, carbon content of austenite increase significantly. However, it have little changes in grain size, volume fraction and carbon content of austenite after the second kind of hot-rolled sheet is annealed. There are also differences in distribution of retained austenite between the two annealed microstructures observed by EBSD and TEM technology. Retained austenite in the first annealed microstructure distributes mainly inside of the polygonal ferrite in the form of spot, only little retained austenite on bainte ferrite boundary, however retained austenite in the second annealing microstructure allocates several places, such as inside of polygonal ferrite, on polygonal ferrite boundary, on bainte ferrite boundary.
关键词:
TRIP steel;hot-rolled;heredity;microstructure;annealing
徐卫兵
,
戈明亮
,
何平笙
应用化学
doi:10.3969/j.issn.1000-0518.2001.09.011
用熔融插层法制备聚甲醛/蒙脱土纳米复合材料,用X射线衍射研究聚甲醛及复合材料的微观结构,表明复合材料是纳米复合材料.用DSC法研究其非等温结晶行为,对所得数据分别用Jeziorny法、Ozawa法和Liu法进行处理.结果表明,Jeziorny法和Liu法处理非等温结晶过程比较理想.聚甲醛及聚甲醛/有机蒙脱土纳米复合材料的结晶活化能分别为334.6和196.9 kJ/mol,说明有机蒙脱土的加入,降低了聚甲醛的结晶活化能,且t1/z缩短,起到了异相成核的作用.
关键词:
聚甲醛
,
蒙脱土
,
纳米复合材料
,
非等温结晶动力学
王平华
,
徐国永
应用化学
doi:10.3969/j.issn.1000-0518.2004.08.007
用熔融复合法制备聚丙烯/凹凸棒土纳米复合材料,用DSC法研究其非等温结晶行为,对所得的数据分别用Jeziorny法、Ozawa法和Liu法进行处理.结果表明,Jeziorny法和Liu法处理非等温结晶过程比较理想.聚丙烯及聚丙烯/凹凸棒土纳米复合材料的结晶活化能分别为194.1和162.8 kJ/mol,表明凹凸棒土的加入,降低了聚丙烯的结晶活化能,且t1/2缩短,起到了异相成核作用.
关键词:
聚丙烯
,
凹凸棒土
,
纳米复合材料
,
非等温结晶动力学
崔忠兴
腐蚀学报（英文）
油井缓蚀剂研究与应用崔忠兴(中原油田设计院,濮阳457001)1.前言中原油田已进入高含水期,油井系统腐蚀严重,直接影响了油田的正常生产l’].为了解决油井系统腐蚀问题,在中科院腐蚀所的专种“基础f,联合开发研制了!MC—SDeZS油井缓蚀剂.该剂以合成炔氧甲基胺和炔氧甲基季法盐衍生物,以这两种衍生物为主体成分复配辅助成分而成的水溶油分散吸附成股型缓蚀剂l’1.通过室内高温高压模拟评价试验.ZI口油井加药试验及测试表明l‘],平?...
关键词:
null
,
inhibitor
,
IMC-80-2S
Scripta Materialia
A recent comment on a previously published paper addressed the invalid explanation of the off diagonal interdiflusion coefficients of the beta-Ni(Al,Cr) phase in the Ni-Cr-Al system according to the symmetric property of the thermodynamic matrix. In this paper, the experimental data presented by Hou et al. was reanalyzed and the interdiffusion coefficient matrix was estimated again. The results of the analysis have been discussed in terms of a brief reply to the comments of Liu and Liang. (C) 2010 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
关键词:
Diffusion;Intermetallic compound;Ni-Cr-Al
邓超
,
邵玮
,
李春忠
高分子材料科学与工程
采用元机纳米锑掺杂二氧化锡(ATO)和有机聚醚酯(PEE)协同提高聚时苯二甲酸乙二酯(PET)的抗静电性能,合成了聚对苯二甲酸乙二酯-聚醚酯/锑掺杂二氧化锡纳米复合材料(PET-PEE/ATO).使用Czawa方程和Liu-Mo方程研究了PET-PEE/ATO纳米复合材料的非等温结晶过程.Ozawa方程研究发现,在非等温结晶过程中,PET、PET-PEE、PET/ATO、PET-PEE/ATO的成核性能依次提高.Liu-Mo方程发现,ATO和PEE的加入分别促进了异相成核作用和加快了结晶生长,PET-PEE/ATO结晶成核性能最好,结晶速率最快.
关键词:
聚对苯二甲酸乙二酯
,
有机聚醚酯
,
无机纳米锑掺杂二氧化锡
,
纳米复合材料
,
非等温结晶动力学
材料研究学报
1994年度高分子材料学科面上基金的申请和评审简况1994年度高分子材料学科的面上项目的各项工作已于八月初基本完成.与L年度情况相比,申请项目总数由259项减到242项,其中高技术探索项目由ZI项增为26项,申请经费平均强度由8.16万元/项,增至8,74万元/项本年度共有90个单位申请,其中对个科学院或部门研究所申请54项,67所高等院校或所属研究所申请188项.按照“依靠专家,发挥民主,择优支持,公正合理”的评审方针,共述选了41项予以资?...
关键词:
王浩
,
刘国权
金属学报
doi:10.3321/j.issn:0412-1961.2008.07.001
以MacPherson-Srolovitz提出的三维个体晶粒长大拓扑依赖速率方程以及三维晶粒组织的晶粒尺寸-晶粒面数间的抛物线型统计关系为基础,导出了相应的描述三维准稳态晶粒尺寸分布的函数族.采用纯Fe实验数据以及顶点法、基元演化法.相场模型和Monte Carlo法进行了验证,结果表明,函数族中峰值左偏的函数适合三维准稳态晶粒尺寸分布的定量表述.将该函数与Liu等提出的2种三维准稳态晶粒尺寸分布函数进行的对比表明:此3种函数的解析表达形式有所不同,但其曲线图在一定条件下相互吻合.此外,MacPherson-Srolovitz三维拓扑依赖速率方程、Hillert三维速率方程及Yu-Liu三维速率方程尽管表达形式不同均能较好地反映三维正常晶粒长大的动力学规律.
关键词:
三维晶粒长大
,
准稳态晶粒尺寸分布
,
长大速率方程
,
计算机仿真
