Yanzhao LUO
金属学报(英文版)
Based on thermodynamics calculation, the results of the formation temperature of MnS inclusions of non-quenched and tempered steel during heating process were discussed. It is shown that while the solid fraction is 0.9, MnS inclusions began to precipitate in the final stage of solidification. The solidification process of 49MnVS3 non-quenched and tempered steel during heating has been observed in situ using a confocal scanning laser microscope (CSLM), which agrees well with the thermodynamics calculation. MnS particles were coarsening during heating process, which would reduce the pinning effect on the austenite grain boundaries and bring about the sudden growth of some austenite grains in this stage.
关键词:
Confocal laser scanning microscopy
杨立新
,
巴黎明
,
李星
工程热物理学报
本文应用MUSIG模型[1]和均一直径模型对某溶液堆台架模型堆芯内气液流动传热进行了数值模拟.在MUSIG模型中堆芯内离散相气泡被分为5组不同直径的气泡,用于分析堆芯内气泡的流动变化和大小分布,采用Luo and Svendsen[2]和Prince and Blanch[3]模型描述不同直径气泡组间的破裂和聚合.在均一直径模型中,堆芯内的气体被考虑为同一直径的组分,并且不考虑其破裂与聚合现象.计算得到采用两个模型的模拟结果并且对其进行了对比研究.结果显示应用MUSIG模型的计算结果与台架实验结果吻合更好.
关键词:
MUSIG
,
均一直径
,
两相流
,
溶液堆
