Y. L. Zhang1) and G. Spinks2) 1) Departmentof Mechanical Engineering
,
Ngee Ann Polytechnic
,
535 Clementi Road
,
Singapore5994892) Intelligent Polymer Research Institute
,
University of Wollongong
,
Northfields Ave
,
Wollongong
,
NSW
,
Australia
,
2522
金属学报(英文版)
Arolled mild steel wascoated byconductive polymers( polyaniline/ MMPand polyaniline/HCSA) andthenim mersedin hot water(50 ℃) fordifferenttimesforstudytheadhesion ofcoatings.It wasfound thatthe adhesion tendsto decrease over time. Thestudyshown that onebrittle and porous Fe3 O4 layer formed between conductive polymercoating and steelsub stratein a moistenvironmentand, asa result, decreased thecoating adhesions.
关键词:
conductive polymercoating
,
null
,
null
J.Wang School of Mechanical
,
Manufacturing and Medical Engineering
,
Queensland University of Technology
,
GPO Box 2434
,
Brisbane
,
Qld. 4001
,
Australia
金属学报(英文版)
An experimental investigation is outlined for the CO 2 laser cutting process of metallic coated sheet steels, GALVABOND. It shows that by proper control of the cutting parameters, good quality cuts are possible at high cutting rate. Visual examination indicates that when increasing the cutting rate to as high as 5000 mm/min (about 100 times that suggested previously), kerfs of better quality can be achieved. Some kerf characteristics such as the width, heat affected zone and dross in terms of the process parameters are also discussed. A statistical analysis has arrived at a recommendatio on the optimum cutting parameters forprocessing GALVABOND.
关键词:
laser cutting
,
null
,
null
