Hongyang JING
,
Lianyong XU
,
Lixing HUO
,
Yufeng ZHANG
材料科学技术（英文）
The changes in mechanical properties and fracture toughness by dynamic loading were investigated with experiments. The parameter R, which can reflect the effect of the loading rate and the temperature rising during the high loading rate, could be employed to describe the constituent relation for the typical structure steel and its weld metal. The dynamic loading effect on the stress/strain fields and the temperature variation in the vicinity of the crack tip was analyzed by the finite element method, the dynamic fracture behavior was evaluated based on the local approach. It has been found that the Weibull stress is an effective fracture parameter, independent of the temperature and the loading rate.
关键词:
Fracture toughness
,
null
,
null
Hongyang JING
,
Lianyong XU
,
Lixing HUO
,
Fumiyoshi Minami
材料科学技术（英文）
The relationship between Charpy absorbed energy and the fracture toughness by means of the (crack tip opening displacement (CTOD)) method was analyzed based on the Weibull stress criterion. The Charpy absorbed energy and the fracture toughness were measured for the SN490B steel under the ductile-brittle transition temperature region. For the instrumented Charpy impact test, the curves between the loading point displacement and the load against time were recorded. The critical Weibull stress was taken as a fracture controlled parameter, and it could not be affected by the specimen configuration and the loading pattern based on the local approach. The parameters controlled brittle fracture are obtained from the Charpy absorbed energy results, then the fracture toughness for the compact tension (CT) specimen is predicted. It is found that the results predicted are in good agreement with the experimental. The fracture toughness could be evaluated by the Charpy absorbed energy, because the local approach gives a good description for the brittle fracture even though the Charpy impact specimen or the CT specimen is used for the given material.
关键词:
Local approach
,
null
,
null
,
null
Wenxian WANG
,
Lixing HUO
,
Yufeng ZHANG
,
Dongpo WANG
,
Hongyang JING
材料科学技术（英文）
A new welding electrode, low transformation temperature electrode (LTTE), was introduced in this paper. It was described in design principle, mechanics, chemical compositions of their deposited metal and manufacturing methods. It was proved that the best transformation starting temperature from austenite to martensite of the deposited metal of LTTE was at about 191°C and it was obtained by adding alloying elements such as Cr, Ni, Mn and Mo. The microstructure of the weld metal of the LTTE was low carbon martensite and residual austenite. The compressive residual stress was induced around the weld of the LTTE and the –145 MPa in compression could be obtained in middle of weld metal. The fatigue tests showed that the fatigue strength of the longitudinal welded joints welded with the LTTE at 2´106 cycles was improved by 59% compared with that of the same type of welded joints welded with conventional E5015 and the fatigue life was increased by 47 times at 162 MPa. It is a very valuable method to improve the fatigue performance of welded joints.
关键词:
Low transformation temperature electrode
,
null
,
null
