Lihui ZHU
,
Xueming MA
材料科学技术（英文）
2.25Cr-1.6W-V-Nb developed in Japan, is a low alloy heat resistant steel with good comprehensive properties. Influence of long term creep at elevated temperature on the structure of 2.25Cr-1.6W-V-Nb steel was studied in this paper, and the micromechanism of creep strength degradation was elucidated, too. Both TEM observation and thermodynamic calculation reveal that during creep the transformation occurs from M7C3 and M23C6 to M6C, which can be cavity nucleation sites. Besides, creep at 600℃ also leads to the decrease of dislocation density, the coarsening and coalescence of M23C6, the nucleation of cavities and development of cracks. The strength decrease of 2.25Cr-1.6W-V-Nb steel after long term creep is related to the decrease of dislocation hardening, precipitation hardening, solution hardening, the nucleation of cavities and development of cracks.
关键词:
Heat resistant steel
,
null
,
null
Yuanzheng YANG
,
Qiaoshen LI
,
Youlan ZHU
,
Xueming MA
,
Yu
,
a DONG
材料科学技术（英文）
Amorphous and nanostructural Fe-B alloys made by mechanical alloying of elemental Fe and amorphous B powders have been studied using X-ray diffraction, differential scanning calorimetry and Mössbauer spectroscopy. It has been shown that the milling conditions have a strong effect on the alloying. The single-phase amorphous alloy, which is limited at nominal composition of Fe60B40, has been produced only by milling in Ar atmosphere and in other composition range the mixture of nanostructure Fe-like phase and Fe2B compound with a little amorphous phase are obtained. While by milling in air atmosphere the introduction of oxygen in air may suppress the formation of amorphous phase, thus the compounds Fe2B may be synthesized with no trace of amorphous phase. The crystallization temperatures of amorphous phase in the resultant products are higher than those of a single amorphous alloy Fe60B40, and hardly independent of the milling conditions and the composition. In addition, it is revealed that detectable B content in the final products is lower than the nominal composition of all the initial samples, which indicates that some B atoms may be located in the disordered interfacial regions of the nanostructural alloyed mixtures.
关键词:
