G Magudeeswaran
,
V Balasubramanian
,
G Madhusudhan Reddy
,
T S Balasubramanian
钢铁研究学报(英文版)
Quenched and tempered steels are prone to hydrogen induced cracking in the heat affected zone after welding. The use of austenitic stainless steel consumables to weld the above steel was the only available remedy because of higher solubility for hydrogen in austenitic phase. In this investigation, an attempt was made to determine a suitable consumable to replace expensive austenitic consumables. Two different consumables, namely, austenitic stainless steel and low hydrogen ferritic steel, were used to fabricate the joints by shielded metal arc welding (SMAW) and flux cored arc welding (FCAW) processes. The joints fabricated by using low hydrogen ferritic steel consumables showed superior transverse tensile properties, whereas joints fabricated by using austenitic stainless steel consumables exhibited better impact toughness, irrespective of the welding process used. The SMAW joints exhibited superior mechanical and impact properties, irrespective of the consumables used, than their FCAW counterparts.
关键词:
shielded metal arc welding process;flux cored arc welding process;austenitic
