Sen YANG
,
Yunpeng SU
,
Zhenxia LIU
,
Weidong HUANG
,
Yaohe ZHOU
材料科学技术（英文）
Cellular spacing selection of Cu-27.3 wt pct Mn alloy has been investigated by laser surface rapid resolidification experiments. The experimental results show that there exists a wide distribution range in cellular spacing under ultra-high temperature gradient and rapid solidification conditions and the average spacing decrease with increase of the growth rate. The experimental results are compared with the current KGT model for rapid cellular/dendritic growth, and a reasonable agreement is found.
关键词:
Sen YANG
,
Wenjin LIU
,
Minlin ZHONG
,
null
,
null
材料科学技术（英文）
A Ni-base alloy composite coating reinforced with TiC particles of various shapes and sizes on medium carbon steel substrate was produced by multilayer laser cladding. The chemical compositions, microstructures and surface morphology of the cladded layer were analyzed using energy dispersive X-ray spectroscopy (EDX), scanning electron microscope (SEM), and X-ray diffractometry (XRD). The experimental results showed that an excellent metallurgical bonding between the coating and the substrate was obtained. The microstructure of the coating was mainly composed of γ-Ni dendrites, a small amount of CrB, Ni3B, M23C6 and dispersed TiC particles. Much more and larger TiC particles formed in the overlapping zone, which led to a slightly higher microhardness of this zone. The maximum microhardness of the coating was about HV0.21200. The effects of the laser processing parameters on the microstructures and properties of coating were also investigated.
关键词:
Laser cladding
,
null
,
null
,
null
Sen YANG
,
Yunpeng SU
,
Wenjin LIU
,
Weidong HUANG
,
Yaohe ZHOU
材料科学技术（英文）
The detailed laser surface remelting experiments of Cu-31.4 wt pct Mn and Cu-26.6 wt pct Mn alloys on a 5 kW CO2 laser were carried out to study the effects of processing parameters (scanning velocity, output power of laser) on the growth direction of microstructure in the molten pool and cellular spacing selection under the condition of ultra-high temperature gradient and rapid directional solidification. The experimental results show that the growth direction of microstructure is strongly affected by laser processing parameters. The ultra-high temperature gradient directional solidification can be realized on the surface of samples during laser surface remelting by controlling laser processing parameters, the temperature gradient and growth velocity can reach 106 K/m and 24.1 mm/s, respectively, and the solidification microstructure in the center of the molten pool grows along the laser beam scanning direction. There exists a distribution range of cellular spacings under the laser rapid solidification conditions, and the average spacing decreases with increasing of growth rate. The maximum, λmax, minimum, λmin, and average primary spacing, , as functions of growth rate, Vb, can be given by, λmax=12.54 , λmin=4.47 , =9.09 , respectively. The experimental results are compared with the current Hunt-Lu model for rapid cellular/dendritic growth, and a good agreement is found.
关键词:
Laser surface remelting
,
null
,
null
,
null
