欢迎登录材料期刊网

材料期刊网

高级检索

  • 论文(3)
  • 图书()
  • 专利()
  • 新闻()

等离子喷涂铈酸镧热障涂层

马文 , 郭洪波 , 宫声凯 , 董红英

无机材料学报 doi:10.3724/SP.J.1077.2009.00983

采用等离子喷涂铈酸镧(La2Ce2O7, LC)粉末制备了铈酸镧热障涂层(TBCs).由于等离子喷涂过程中CeO2的挥发量较多,造成涂层的实际成分为La2Ce1.66O4.32,与原始粉末成分相比有所偏离.在1400℃下经240h热处理后LC涂层发生轻微的分解.在1000℃下LC块材的热导率约为0.51W/(m·K),比传统的氧化钇部分稳定的氧化锆(YSZ)块材的热导率降低了约75%.LC涂层的热膨胀系数(CTE)在450~1100℃范围内介于10×10-6~13×10-6K-1,与相应温度范围内的YSZ相比较高.热膨胀性能测量表明,LC涂层从室温升到1250℃时发生轻微的烧结,在1250℃保温过程发生明显的烧结现象.LC热障涂层在1100℃条件下经60次热循环后从陶瓷层内部发生剥落.

关键词: 热障涂层 , lanthanum-cerium oxide , plasma spraying , thermal cycling

热循环对TC4钛合金组织和机械性能的影响

耿洪滨 , 何世禹 , 雷廷权

金属学报

对淬火态和时效态的TC4钛合金在-196-350℃进行了热循环试验,并测定了合金热循环前后的机械性能.结果表明:经热循环后,合金的塑性下降;时效态的合金,强度变化较小.而淬火态的合金,强度先显著上升,经3000次热循环后,合金的强度又有所下降.用透射电镜分析了合金热循环前后的组织,讨论了热循环对显微组织和机械性能的影响.

关键词: 钛合金 , thermal cycling , tensile property

IN SITU METALLOGRAPHIC OBSERVAION OF THERMAL CYCLING EFFECTS ON PHASE TRANSFORMATION IN Cu-Zn-Al SHAPE MEMORY ALLOY

M Liu , X.M Zhang , M.Z. Liuand R.S. Liu(Metal Material Department , Sichuan Union University , Chengdu 610065 , China) (Institute of Metal Research , Chinese Academy of Sciences , Shenyang 110015 , China)

金属学报(英文版)

In this paper, an in situ metallographic video system was used to study the morphology in Cu-Zn-Al shape memory alloy (SMA) during thermal cycling phase tmnsforma-tion. There are seven different types of martensite morphology in Cu-Zn-Al SMA,i.e. plate, spean bamboo, noose, round-spot, line and dot-like martensites. During transformation and inverse-transformation, the thermoelastic martensites were rising and falling, growing and shrinking, splitting and merping. The growth patterns of thermoelastic martensite were divided into three types: fast growing, very slow ex-pansion and uniform automatic growth. Automatic growth appeared when ageing at a temperature below Ms. The result, for the first time, coofirmed Olson and Cohen,s suggestion that thermoelastic martensite may be automatically grown when ageing be-low Ms. With increasing numbers of thermal cycling, both the memory recovery ratio (% )and memory recoverp degradation (%) degraded logarithmically. The degrada-tion was steep in the initial stage and then became more and more gradual in the middle and the final stages caused by the stabilisation of martensite. In the initial stage, vacancies assumed the controlling role, while dislocations took the major role in other stages. The martensite transformation caused the intedeces to become bent and blurmd, but with increasing cycling numbers, the movements of interface had the same degradation effects as the memory recovery ratio curves. Under these conditions, we also found the martensites on one side of the intedece became reorientated and par-allel to the intedece. It was therefore concluded that the movement degradation of the interface and the appearance of bamboo like martensite induced the degradation of two way shape memory effect (TWMP).

关键词: in situ metallographic video study , null , null , null

出版年份

刊物分类

相关作者

相关热词